 |
|
|
|
u |
|
 |
The Original
The All New Amazing...
Disappearing Hose
|
 |
|
|
Built-In Fully Automatic Retractable 45 Ft. Electric Hose
The
Hose Genie Makes All The Difference...
28 Years Of Rock Solid Technology!
u
u
u
|
|
Hose
Genie is the first patented, push-button hose management
system on the market today. Like magic, the hose
dispenses and disappears inside the wall.
Floor tools and an
electric brush can be added to the system and are priced
separately. Each Hose Genie station contains a separate
hose that reaches up to 2,000 sq. ft. Several can be
positioned throughout the home depending on size and floor
plan. Example: a 3800 sq. ft. two story home may require
2 stations down and 1 station up. It features button
controls on a swivel handle for all functions on a 45 foot
hose with an inside hose diameter of 1.44 inches for
maximum air flow.
The Hose Genie
has a reset button in the event the floor brush becomes
clogged and the unit stops, and a fuse if the retractor
ceases working. These are easily accessible on the top of
the circuit board cover behind the retractor unit. The
unit is designed normally for new construction, remodeling
or updating your present central vac system for easy Hose
Management.
u
|
|
 |
|
u |
|

u |
|
"One Touch"
Fully Electric Hose
Use
As Much Hose As You Like - Up To 45 Ft.
Can
Be Used With Electric Carpet Nozzle
|
|
|
What type
of carpet nozzles and/or floor tools can be used with this
hose?
Any
carpet nozzle or floor tool can be used with the Hose
Genie including electric carpet nozzles, unlike
other retractable systems that require air driven tools.
We strongly recommend avoiding the use of air driven
nozzles such as the Turbocat Zoom, Turbocat Ex, Miele
Turbo Nozzle etc. Air driven nozzles will perform poorly
due to the hose length and the amount of air travel. Air
driven nozzles depends solely on the strength of the
vacuum unit. All bare floor tools will work fine with the
Hose Genie.
Does The Hose Retract Electronically or With Suction?
The Hose Genie has a fully electric "push-button"
retractable hose which assures a constant smooth in & out
motion. Hose management systems that use suction tend to
get stuck in the wall often during retraction and can slow
down with the age of your vacuum. Also, many other
retractable systems use hose sock covers which may get
dirty and prevent a smooth retraction when using a suction
geared system. Other retractable systems that use suction
for retraction are very problematic, due to a poor design
that uses the vacuum unit to retract. When the hose is
retracting it causes turbulence in the piping, which
lessens the strength of the vacuum, which may cause the
hose to become stuck. This can be a very frustrating
process.
What Are The Chances of The Hose Genie Clogging?
Any central vacuum hose is capable of clogging, however
the Hose Genie is virtually impossible to clog due to it's
1.44 inch interior diameter. In the event that the hose
clogs, the 1.44 inch interior diameter makes it very easy
to "snake" out.
|
|

|
|
The unit consists of:
The Retractor
Cabinet
The
Retractor Cabinet is 30" long x 12" high x 3.5" deep with
a 14.5" x 10.5" opening for the hose handle, and is
designed to be installed between the studs on 32" centers
at approximately 48" above the floor.
Hose Storage
Cavity Liner
The hose cavity liner is
thin plastic sheet material that lines the cavity where
the hose is stored. The cavity liner provides a clean
storage container and protection for the hose.
The Retractor
The
Retractor is designed to easily snap apart so the hose can
be placed into contact with the drive mechanism. Once the
hose is in place, the Retractor snaps back together so it
can be positioned properly in the Retractor Cabinet.
A 120VAC "power-in"
operates the retractor, a 120VAC "power-out" operates the
electric floor brush and a "low-voltage" control for the
vacuum system source are all located for easy plug-in to
the retractor.
The Hose
The 45' vacuum hose
includes a fitting (provided) for connecting to the vacuum
source line. This fitting is glued directly to the 2"
P.V.C. vacuum line entering the Hose Retractor Cabinet
from the Vac Magic or an existing central vacuum. Once the
hose end is snapped into place on the fitting, the hose is
loaded into the lined storage area (cavity liner) and then
installed into the Retractor.
With hose installed, the
Retractor is inserted in the front opening of the
Retractor Cabinet, all plug-ins made and slid to the right
and snapped in place. After drywall
installation and painting are complete, the front cover
door may be installed with the door opening to the right.
A rubber snout cover is to be used on the handle snout
where multiple HOSE GENIES are connected to the same
vacuum source so there will be a vacuum at the next
station.
|
|

|
|

|
|
"The Hottest
Trend In
Central Vacuum Technology" |
|
The
Hose Genie - 2008's Hottest Item!
All
Inclusive - No Need To Piece Together! |
 |
All-In-One
Hose Genie
All in one, fully
inclusive
package with Hose
&
Rough-In/Finishing Kit.
Each Hose Genie station
contains a Retractable
45 Ft hose. |

u
1
Hose Genie Can
Do
Up To
2,000 Sq. Ft. |
Stop Dragging Around Your Hose...
Makes Vacuuming A Breeze! |
|
|
|
u |
|
Add An
Attachment Kit |
|
Standard
u
Bare Floor
Kit |
 |
|
|
|
Deluxe
u
Attachment
Kit |
 |
|
|
|
Elite
u
Attachment
Kit |
 |
|
|
|
| u |
|
|
|
Call us
Toll Free 800-322-2965
© Copyright www.ThinkVacuums.com 2008 Coral Springs,
Florida 33065 Our Retail Location Hours are
Monday-Friday 8-6, Saturday 10-4
|
|