SEBO DISCO Floor Polisher
Introduces a new sophisticated
and highly efficient floor-pad
technology that produces a high
gloss effect without the use of
water, chemicals or polishing sands.
The new pad technology achieves its
results by using four different
floor pads, each of which is
designed to accomplish distinctly
different tasks. The pads are
color-coded to assure proper
selection. In addition, they are
highly abrasion resistant and have a
life expectancy of over 100,000
The DISCO is usually suitable for
the following types of floors:
PVC (coated or uncoated vinyl or
vinyl composite tiles).
Natural stone, such as granite,
marble or terrazzo.
Acrylic or polyurethane-coated
Hardwood with oil or varnish
Hardwood or other floors with
soft coated finishes, like wax
(use the blue floor pad only).
The Red, Yellow and Green Floor Pads
Restore the shine of dull,
scratched and scuffed hard-floor
surfaces without the use of water,
chemicals or polishing sands. The
pads do the work using the following
three-step procedure (soft coatings
should not be present):
Step One. The Red Floor
Pad – removes the deepest or
most visible scratches and
smoothes the floor surface.
Thus, it prepares the floor for
the yellow pad.
Step Two. The Yellow
Floor Pad – restores a higher
gloss finish and prepares the
floor surface for the green pad.
Step Three. The Green
Floor Pad – creates the final
gloss finish in the “three-step
process,” and it is suitable for
daily use to maintain the
floor’s high gloss finish.
The Blue Floor Pad
Is designed to maintain soft
coatings, like wax, on hard floors,
and it is suitable for daily use as
well. It should be used along with a
typical floor wax suitable for the
specific floor surface or
recommended by the flooring
manufacturer. And because the DISCO
has suction ability while polishing,
it removes the fine dust from fully
dried floor-wax products.
The DISCO is NOT
suitable for the following types of floors:
- Any floor on which a
shiny finish is not desired.
- Glazed, ceramic and
porcelain tiles, or porous tiles such as terracotta or
- Cushioned vinyl,
linoleum, laminate, and any floor types that are poorly
bonded to the sub-floor.
- All floors with
textured or uneven surfaces or tiles with raised edges.
- Floors with
maintenance-free coatings, floors in which acceptability
of the polisher is uncertain, or when polisher use is
contrary to manufacturer recommendations.
the shine of hard floors is difficult, due to the following
- Small and medium-size
furnished hard-floor areas do not easily accommodate
- Big, heavy, hard-floor
polishing machines are difficult to use, require trained
staff and are expensive.
- Regular maintenance of
hard floors is costly and time consuming.
- Typical hard-floor
polishers have limited flexibility and mobility.
- Most hard-floor
polishers cannot reach small areas.
- Correct use of
floor-care chemicals and polishing sands is difficult
and requires sophisticated knowledge.
The DISCO Polisher is the
solution to all of these problems, and it is built to
* PLEASE NOTE: Suitability of all floor surfaces
should first be determined by consulting the manufacturer
recommendations, and then by testing the DISCO and its four
pads in an inconspicuous spot. If floor damage occurs,
immediately discontinue use.